Faded, patchy pavers made even again
Paver Restoration and Resealing in Bunnell, FL
Call (386) 337-3172 for a free estimate to restore the pavers at your Bunnell home.
- Brings out deeper paver color
- Fresh joint sand helps lock pavers in place
- Gives weeds less room to grow
- Makes the surface easier to keep clean
- Free estimate, no obligation
Request a Free Estimate
Free, no obligation.
How fast can someone restore my pavers in Bunnell?
Paver restoration is offered throughout Bunnell, FL, with a reply from a local contractor inside 1 business day, usually much sooner. The visit and the estimate are free. To begin, call (386) 337-3172.
Restoration is for pavers that need more than a rinse: peeling or cloudy sealer, sunken corners, weeds in the joints and color that has gone chalky. The goal is a surface that looks evenly dark again and drains the way it should. A walk around the yard shows the contractor how deep the problem goes. Share photos or a description when you request your free estimate.
Do my pavers need restoring, resealing or replacing?
Three levels of work cover almost every driveway. Match your pavers to the closest one, then let the contractor confirm. To go over yours, call (386) 337-3172.
Reseal only
The pavers sit level, the joints are full and the old coat is thin but even. A wash, fresh sand and a new coat are enough.
Restore
The sealer is white, peeling or blotchy, a few areas dip, weeds keep returning or the color has faded. Repairs, stripping and tinting join the usual steps.
Replace
Large areas have sunk because the base failed, or the drainage sends water under the pavers. A repair of the base comes before any sealer.
Which signs say Bunnell pavers are due for restoration?
- Color has faded or gone blotchy, with dark patches next to pale ones.
- Sealer looks white, cloudy or peeling instead of clear.
- Corners or wheel tracks have dipped below the pavers beside them.
- Weeds and ants keep coming back through the joints.
- Sand has washed out after heavy rain and the joints sit low.
- Green or black growth returns within weeks of a wash, mostly in shade.
Those signs match a list one Florida paver company gives for when service is due. Even two or three of them are worth a look. To have a contractor check, call (386) 337-3172.
Why do pavers sink or shift on Bunnell lots?
A Bunnell paver company says soil here varies, with some areas holding more clay than the coast, so the depth of the base has to be set on site. A Florida restoration company adds that poor base work causes settling around pools and driveways. Water is the other half: it needs a path away from the pavers, and the slope matters most at pool decks. To have a low spot looked at, request your free estimate.
Rain does its own damage. A Flagler County paver company says rain washes out the sand that keeps pavers from shifting, and the town sits only about 10 feet above sea level, so water moves slowly after a storm. Joints that run low let pavers wobble. Tell the contractor when the dip started when you call (386) 337-3172.
What is the process order for a paver restoration?
The sequence below follows what Florida restoration companies describe, and the order is the point. Repairs and dry joints come before any sealer. To see the plan for your pavers, request your free estimate.
1. Inspect
The contractor walks the area, notes sunken spots and failing edge restraints and explains what is happening.
2. Correct
Low pavers are lifted, the base is built back and the pavers go down level.
3. Stabilize joints
Polymeric sand is set in the joints to cut washout, weeds and ants.
4. Strip and steam
Failed sealer is removed, then the surface is steam cleaned, with stains treated as they show.
5. Restore color
Faded pavers can get color enhancement, a tint or a UV-resistant coating.
6. Seal
A sealer made for Florida sun goes on dry pavers, at the coverage printed on the label.
Does old sealer have to come off before resealing?
When it is cloudy, peeling or blotchy, yes. A new coat over a failed one bonds poorly and shows every flaw. Paver companies list strip and reseal as its own service for that reason. Unilock, a paver maker, adds that extra layers lead to patchy gloss and a whitish film. Ask whether stripping is in the quote when you call (386) 337-3172.
If the old coat is only thin, a clean surface and a thin new coat may do. Dry time then decides the schedule. Glaze 'n Seal asks for 24 hours dry before sealing and 48 when the pavers were just washed. Mention any recent rain when you request your free estimate.
Can faded pavers get their color back?
Often they can, to a point. A Florida paver company lists color enhancement for faded pavers, and another lists a color additive and color staining. A UV-resistant coat is offered to slow fading afterward. Sealers come in gloss, matte and natural looks, so decide how shiny you want the driveway. Ask for a small test patch when you request your free estimate.
What does paver restoration cost in Bunnell?
A restoration costs more than a reseal because it adds repair, stripping and color work. One Florida company publishes size bands that fall as the area grows, shown next to the regional range below. For a number based on your driveway, call (386) 337-3172.
| Paved area | Typical example | Clean, sand and seal at $1.50 to $3.00 | Restoration rate published by one Florida company |
|---|---|---|---|
| 400 sq ft | Back patio | $600 to $1,200 | $1,284 |
| 800 sq ft | Standard driveway | $1,200 to $2,400 | $1,936 |
| 1,500 sq ft | Driveway and walk | $2,250 to $4,500 | $3,630 |
| 3,000 sq ft | Large estate drive and deck | $4,500 to $9,000 | $5,970 |
The middle column is the $1.50 to $3.00 per square foot that Northeast Florida paver companies listed as of November 2026. The last column uses a Florida company's published bands, which include steam cleaning, joint sand and sealer: $3.21 a square foot up to 700 square feet with a $1,200 minimum, $2.42 from 701 to 2,500 and $1.99 above that. Leveling sunken areas, removing failed sealer and tinting are priced as add-ons, so your contractor sets the final number after a visit.
How do restored paver surfaces look in the Bunnell area?
How long should a restored surface last?
Plan on two to four years before the next coat. A Florida paver company says most homeowners reseal every two to three years, and Western Interlock, a paver maker, suggests three to four. Open sun, sprinklers and daily cars shorten it, and covered spots stretch it. Put the date in your phone when the work is done, and call (386) 337-3172 when water stops beading.
Thicker is not better. Family Handyman says sealing more often adds no protection, so a quote that pushes extra layers is worth a question. A thin, even coat does the job. Ask how many coats are planned when you request your free estimate.
Is a long rural driveway harder to restore?
It adds area and setup rather than difficulty. A Bunnell paver company says large rural lots and long driveways are served and that access and equipment needs are checked at the estimate. A drive that runs far from the road may need a longer hose run or a water supply nearby. Give the road name and a rough length when you request your free estimate.
Which nearby towns get paver restoration estimates?
A contractor who covers Bunnell also serves the towns linked below. Choose yours, or call (386) 337-3172.
Frequently Asked Questions
What is the average cost to seal pavers in Florida?
Companies in Northeast Florida list about $1.50 to $3.00 per square foot to clean, sand and seal. A restoration with repairs and sealer removal sits above a plain reseal. Ask for each part priced on its own line.
How often do you need to reseal pavers in Florida?
A Florida paver company says most homeowners reseal every two to three years, while Western Interlock, a paver maker, suggests three to four. The gap comes from sun, sprinklers and traffic. When water stops beading, the coat is done.
Is it good to seal pavers in Florida?
After a restoration it usually is. Sun fades pavers, and summer rain washes out the sand between them. Sealer slows both, though it is a cost that comes back every few years.
How much do people charge to seal pavers?
The published range runs $1.50 to $3.00 per square foot for clean, sand and seal. One Florida company lists $3.21 up to 700 square feet, $2.42 up to 2,500 and $1.99 beyond that, with repairs and tinting extra. Small jobs cost more per foot because the visit costs the same.
Why is paver sealing so expensive?
A restoration has more steps than a reseal: repairs, stripping, steam cleaning, joint sand, drying and the coat. Each step needs time and dry weather. A low bid often leaves one of them out.
Do I need a license to install pavers in Florida?
Rules depend on the kind of work, and no licensing page was opened for this site, so there is no rule to quote here. Ask any contractor what license or registration applies to the job and ask to see it. Resealing and cleaning are different from building a new patio.
Will my Bunnell pavers sink again after they are leveled?
It depends on why they sank. A Bunnell paver company says soil here varies and some areas hold more clay than the coast, so base depth is set on site. If water runs under the pavers, they can settle again, so ask about drainage when you call (386) 337-3172.
Can a restoration change the color of faded pavers?
Yes, within limits. Paver companies list color enhancement, color additive and color staining, and a UV-resistant coating to slow fading. A sample on a small corner shows the result before the whole area is done.
Which other paver services are available in Bunnell?
Ready to bring your Bunnell pavers back?
A short call or form starts it, and an answer comes within 1 business day, often sooner.
Free, no obligation